2K Aerosol Full Process
Learn how to use the Raptor 2K Bedliner in Aerosol in a few steps
RAPTOR Acid Etch Primer
Raptor Acid Etch Primer in Aerosol - Prepare Your Substrate before Applying RAPTOR.
RAPTOR Adhesion Promoter
Raptor Adhesion Promoter in Aerosol - Prepare Your Substrate before Applying RAPTOR.
Spray RAPTOR to a prepared OEM Truck Bed
#1: Ensure you apply an even coat, avoiding excessive build in corners. #2: For the first coat, we set up the RAPTOR Gun [...]
RAPTOR a Chassis
#1: Remove as much rust and debris as possible with a coarse abrasive or grinder. #2: Degrease with a solvent-borne degreaser such as [...]
RAPTOR a Bumper
#1: Degrease the substrate with a water-based System 20 degreaser. #2: Abrade with 180-240 grit. #3: Degrease again. #4: Wipe the substrate with [...]
RAPTOR Bonnet and add a Stencil
#1: Spray the vehicle in the colour and texture of your choice. #2: Once fresh RAPTOR has cured, lay the stencil over the [...]
RAPTOR a Wheel
#1: Remove the wheel from the vehicle. #2: Use a pressure washer to thoroughly clean the wheel. Remove all dirt, grime and break [...]
RAPTOR Raptor
#1: We need to repair a dent in RAPTOR. #2: Take off the part which needs to be repaired if you can. #3: [...]